Page 1 of 1
Place Holder Cad models for Acorn kit parts
Posted: Fri Mar 19, 2021 2:16 pm
by swk
trying to patiently await the arrival of the Acorn kit i've ordered to upgrade my CNC Router, but want to get started on my electronics enclosure planning and build while the shipping company takes their time.
Any know where I can find generic models of the parts with enough detail information for planning mounting option?
Thanks
K
Re: Place Holder Cad models for Acorn kit parts
Posted: Fri Mar 19, 2021 3:15 pm
by martyscncgarage
swk wrote: ↑Fri Mar 19, 2021 2:16 pm
trying to patiently await the arrival of the Acorn kit i've ordered to upgrade my CNC Router, but want to get started on my electronics enclosure planning and build while the shipping company takes their time.
Any know where I can find generic models of the parts with enough detail information for planning mounting option?
Thanks
K
Acorn spec manual with dimensions can be found here:
Make cardboard cutout to size for it and the relay board.
https://centroidcnc.com/centroid_diy/do ... manual.pdf
I assume you have your motor drives, power supplies etc...
Patience is a virtue....(of which sometimes I have little of!
)
Re: Place Holder Cad models for Acorn kit parts
Posted: Fri Mar 19, 2021 3:34 pm
by swk
martyscncgarage wrote: ↑Fri Mar 19, 2021 3:15 pm
I assume you have your motor drives, power supplies etc...
Patience is a virtue....(of which sometimes I have little of!
)
Thanks!
yes I have motor drives, PSUs, a pile of DIN rail and wire management.
Trying to get things layed out in CAD so I know if I need to fab any parts.
I'll post some project pix.
and Patience?? whats that?
Re: Place Holder Cad models for Acorn kit parts
Posted: Fri Mar 19, 2021 3:41 pm
by martyscncgarage
Be sure to start a build thread of your project. Post pictures of it and how you get along.
Marty