Page 1 of 1
Acorn on board temperature? (Resolved)
Posted: Wed Feb 03, 2021 5:27 am
by Caleb
I don't know if this is me miss-remembering, I've tried searching the forum and looking through documentation, I'm sure I've seen it somewhere...
Is there an on board temperature reading somewhere in cnc12 info pages?
Re: Acorn on board temperature?
Posted: Wed Feb 03, 2021 8:37 am
by eng199
No.
Re: Acorn on board temperature?
Posted: Wed Feb 03, 2021 7:10 pm
by martyscncgarage
Caleb wrote: ↑Wed Feb 03, 2021 5:27 am
I don't know if this is me miss-remembering, I've tried searching the forum and looking through documentation, I'm sure I've seen it somewhere...
Is there an on board temperature reading somewhere in cnc12 info pages?
It doesn't get hot enough to worry about Caleb. What is your concern??
Re: Acorn on board temperature?
Posted: Thu Feb 04, 2021 2:57 am
by Caleb
No concern, was just wondering if I could use it to check cabinet temperature without any other hardware.