I'm curious what everyone uses the WMPG macro buttons for.
So far I have the following:
Macro1 - G28 (Tool Change Position. Z machine zero, X machine zero - centered on TLO, Y centered on TLO)
Macro2 - G30 (Part loading position. Z machine zero, X centered on vise, Y table all the way forward)
Macro3 - Unused
Macro4 - Z machine zero, X WCS zero, Y WCS zero
What macros have you tied into the WMPG?
What do YOU use the WMPG macro buttons for?
Moderator: cnckeith
-
- Posts: 78
- Joined: Mon Dec 07, 2020 2:20 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 4031
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Gilroy, CA
- Contact: