RTG in an ISO mode?
Moderator: cnckeith
-
fritts22
- Posts: 4
- Joined: Mon Jan 28, 2019 7:50 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
RTG in an ISO mode?
Is there a way to view the RTG screen in an ISO view? Also is there a way to view a combination of the RTG and Gcode screen? I really don't like going between RTG to GCode in order to see all I want.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
tblough
- Community Expert
- Posts: 3536
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: RTG in an ISO mode?
ISO is one of the views cycled through the F2 button. Current G-code line is displayed at top of graphics screen. IMO there is too much information to try to combine both on the same screen.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)