Page 1 of 1
Windows Firewall (Resolved)
Posted: Mon Jan 04, 2021 4:53 pm
by milling
Can I turn my windows firewall back on after I have installed CNC12? Directions were a little confusing? Also it seems that if the fiewalls are on the ethernet will not communicate with the acorn?
Re: Windows Firewall
Posted: Tue Jan 05, 2021 8:54 am
by Nigelo
Re: Windows Firewall
Posted: Tue Jan 05, 2021 9:02 am
by Nigelo
More specifically, use the forum search facility as I have just done. A search on "Firewall" would have brought up Keith's words of wisdom on the following link
viewtopic.php?f=60&t=3232&hilit=firewall
Re: Windows Firewall
Posted: Tue Jan 05, 2021 10:30 am
by milling
thanks
Re: Windows Firewall
Posted: Wed Jan 06, 2021 9:57 am
by martyscncgarage
As a point of interest, if you have a CNC PC with all the Windows 10 updates, when you install CNC12 and then start it for the first time, Windows 10 will give you the opportunity to allow CNC12 through the firewall. Simply check the boxes and allow. Then its done.
Marty
Re: Windows Firewall
Posted: Wed Jan 06, 2021 10:45 am
by milling
ok thanks