I have CNC11 freeze up quite often when I am trying to preview a lengthy intercon program or a 3d program that I created the *.cnc file from Vectric3D. Is there something I can do to remedy this? I have to close CNC11 through the task manager as it is not responding.
Thank you
Brent Lidgard
CNC11 freezing up during toolpath preview
Moderator: cnckeith
-
BrentLidgard
- Posts: 17
- Joined: Thu May 13, 2010 12:19 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: No
CNC11 freezing up during toolpath preview
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Centroid_Liviu
- Posts: 447
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: CNC11 freezing up during toolpath preview
Can you check and see what you have Parameter 260 set to. Set it to -1 if its not already. To get to the parameters screen from the main screen press F1-Setup, F3-Config (default password is 137), F3-Params.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)