Control Cabinet needed
Moderator: cnckeith
-
thomasks
- Posts: 8
- Joined: Sun Dec 09, 2018 9:13 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Control Cabinet needed
I have a small home made CNC router that I have built. It is running with a small box that is designed for sprinkler controls and is too small. I would like to find a used panel say 24x20x8 to put my controls into. If you have an old cabinet laying around, I could use it.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
bdlitzer
- Posts: 8
- Joined: Thu Nov 15, 2018 11:17 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Control Cabinet needed
Where do you live?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)