Page 1 of 1
Tool touch height
Posted: Wed May 22, 2019 11:25 am
by Dholman
Everytime I enter the height to be subtracted in the wizard and save and close the wizard it goes back to zero and does not subtract is there a specific order that needs saved
Re: Tool touch height
Posted: Wed May 22, 2019 11:32 am
by cnckeith
you'll have to post a fresh report.zip
Re: Tool touch height
Posted: Wed May 22, 2019 11:47 am
by Dholman
here is my report
Re: Tool touch height
Posted: Wed May 22, 2019 3:03 pm
by cnckeith
ok...i confirm.. so as a work around.. go to cnc12 and set Parameter 71 to a negative value of the TT height device and it will stick..
then you don't have to worry about the wizard resetting to zero
Re: Tool touch height
Posted: Thu May 23, 2019 1:19 pm
by Dholman
That worked thank you