Page 1 of 1
VCP not working <answered>
Posted: Fri Apr 26, 2019 5:55 pm
by B1 SCOTT
I finally got everything wired up and am ready to jog the motors on my mill. I can't adjust the feedrate with the VCP. I tried other buttons nothing works. I downloaded the latest version 4.14
Re: VCP not working
Posted: Fri Apr 26, 2019 11:28 pm
by B1 SCOTT
Here is a report if it helps. I was on my way out the door to my kids baseball game earlier and was in a hurry.
Re: VCP not working
Posted: Mon Apr 29, 2019 1:58 pm
by cnckeith
message log shows you still have some parameters to set and voltage checks to do..
please follow the allin1dc install manual (recently updated)
https://www.centroidcnc.com/downloads/c ... manual.pdf
and marty's allin1dc install videos.
viewtopic.php?f=20&t=2421
Re: VCP not working
Posted: Tue May 07, 2019 3:45 pm
by AcornJosh
According to the report, the currently used PLC program does not support VCP. Please save a report and follow step 7 of Tech Bulletin 311 to update your PLC and copy your config files.
I suspect you installed 4.14, installed a PLC, and then loaded your older report which loaded the old PLC.