Page 1 of 1
Offset Library wont upload to Tool Library
Posted: Mon Apr 01, 2019 3:29 am
by Turbodime
New member here. I have a Centroid ran knee mill with Centroid 4th axis. Watching the Centroid vid we are at step #4, Programming the Part with Intercon. We have tools in the Offset Library but nothing comes up in the Tool Library. How do we transfer these tools into the tool library? Thanks for any help.
Aaron
Re: Offset Library wont upload to Tool Library
Posted: Mon Apr 01, 2019 11:45 am
by martyscncgarage
Turbodime wrote: ↑Mon Apr 01, 2019 3:29 am
New member here. I have a Centroid ran knee mill with Centroid 4th axis. Watching the Centroid vid we are at step #4, Programming the Part with Intercon. We have tools in the Offset Library but nothing comes up in the Tool Library. How do we transfer these tools into the tool library? Thanks for any help.
Aaron
Aaron, you should create the tool library first. Then do you tool offsets.
Re: Offset Library wont upload to Tool Library
Posted: Mon Apr 01, 2019 1:33 pm
by Turbodime
Thanks we'll look into that. We were following along with the video and it starts with offsets first. We'll start over with manual in hand as we'll I see you're in Mesa. I watched some of your vids and I instantly recognized you. We worked for the same place.
Re: Offset Library wont upload to Tool Library
Posted: Tue Apr 02, 2019 9:23 am
by martyscncgarage
Turbodime wrote: ↑Mon Apr 01, 2019 1:33 pm
Thanks we'll look into that. We were following along with the video and it starts with offsets first. We'll start over with manual in hand as we'll I see you're in Mesa. I watched some of your vids and I instantly recognized you. We worked for the same place.
Start the mill training videos over and watch carefully. Yes, the Mill Operators manual is a good resource. Check out the section on INTERCON. There are some tutorials you can try out to get your feet wet.
Worked for the same place? You've got my attention.
