Acorn Fun
Posted: Fri Feb 08, 2019 10:51 pm
I have had 2 Acorn CNC boards since 2017, the 2nd one was purchased because of user error (always refer to your schematics when re-connecting VFDs and what not).
Never the less the only times I have posted was usually in frustration or when I was confused and I believe I always got a response. It may have not been the response I always wanted but it was always honest.
So today I was looking through the forum and thinking that I really don't have an issue I'm just looking for tips and tweaks. My point is I just wanted to say thank you to all those who have went out of their way to answer my questions in the past, it really helped. I love my machine and while it's not the best one out there it is doing what I want it to. I'm not sure I would be this far along without you.
Never the less the only times I have posted was usually in frustration or when I was confused and I believe I always got a response. It may have not been the response I always wanted but it was always honest.
So today I was looking through the forum and thinking that I really don't have an issue I'm just looking for tips and tweaks. My point is I just wanted to say thank you to all those who have went out of their way to answer my questions in the past, it really helped. I love my machine and while it's not the best one out there it is doing what I want it to. I'm not sure I would be this far along without you.
