Homing Z and tool height offsets?
Moderator: cnckeith
-
jake2465
- Posts: 35
- Joined: Tue Aug 28, 2018 12:53 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: 103298
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Homing Z and tool height offsets?
Does the Z axis need to homed in order to use the tool height offsets? I am under the impression that the only figure the tool height offsets use is the tool number used to set part zero for the Z.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
cnckeith
- Site Admin
- Posts: 8924
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Homing Z and tool height offsets?
yes..
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
(Note: Liking will "up vote" a post in the search results helping others find good information faster)