Intercon
Moderator: cnckeith
-
Dholman
- Posts: 52
- Joined: Mon Aug 06, 2018 11:44 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Intercon
Is there any video's on cnc 12 intercon having hard time getting radius to work on lathe is the pro lathe any better there is no help on it the manual 10 version is useless every time I enter the correct numbers it changes them
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
DICKEYBIRD
- Posts: 536
- Joined: Sat Jul 08, 2017 7:38 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: n/a yet
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Collierville, TN USA
Re: Intercon
Here's a few videos that may help: viewtopic.php?f=61&t=1454 and this: viewtopic.php?f=61&t=1453 and this: viewtopic.php?f=61&t=1756
If you're switching from Mach3, it'll take a while but well worth it. I'm not comfortable with it yet but more "seat" time will help a lot.
If you're switching from Mach3, it'll take a while but well worth it. I'm not comfortable with it yet but more "seat" time will help a lot.
Milton in Collierville, TN
"Accuracy is the sum total of your compensating mistakes."
"Accuracy is the sum total of your compensating mistakes."
(Note: Liking will "up vote" a post in the search results helping others find good information faster)