Schematic
Moderator: cnckeith
-
converterking
- Posts: 129
- Joined: Fri Mar 19, 2010 2:38 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
Schematic
Could you post the schematic for this plc program? centroid allinonedc-lathe-4te-v8.src
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Centroid_Tech
- Posts: 286
- Joined: Thu Mar 18, 2010 2:24 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
Re: Schematic
Here is the schematic that goes with that PLC program.
- Attachments
-
- S13341.r2.pdf
- (108.46 KiB) Downloaded 134 times
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.
Without the above information we may not be able to help and/or reply until the required information is posted..
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
converterking
- Posts: 129
- Joined: Fri Mar 19, 2010 2:38 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
Re: Schematic
Thank you.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)