Is there a script that CNC12 runs when you boot up the software?
I want to add some code to it where it turns on/off some outputs during startup.
Thanks!
CNC12 initializing script
Moderator: cnckeith
-
mael
- Posts: 36
- Joined: Sat Feb 03, 2018 12:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
CNC12 initializing script
(Note: Liking will "up vote" a post in the search results helping others find good information faster)