Page 1 of 1
Acorn6 trying to access the Wizzard and it locks up the system? <cnc12 is running a job>
Posted: Tue Jul 22, 2025 8:13 pm
by PrestonE
Hello,
We have finally gotten the 3 axis's to sort of work.
X and Y fine, with Z we jumper the Enable X axis to the Z axis and it works.
But, we cannot access the Configuration Wizzard?
When we try we get this screen shot and below is the Report after this happens.
The machine is not doing anything else in the background.
How can we fix this?
Best Regards,
Preston
Re: Acorn6 trying to access the Wizzard and it locks up the system?
Posted: Tue Jul 22, 2025 11:01 pm
by ShawnM
See tech bulletin #270. Here's a link:
https://www.centroidcnc.com/dealersuppo ... ds/270.pdf
Your error log is littered with communication errors and it can cause all kinds of problems.
Re: Acorn6 trying to access the Wizzard and it locks up the system?
Posted: Wed Jul 23, 2025 10:10 am
by CentroidFrog
I would suggest installing CNC12 v5.30 and going from there:
https://www.centroidcnc.com/centroid_di ... loads.html
As well as solving the communication issues as ShawnM pointed out.
Related:
viewtopic.php?t=1451
Re: Acorn6 trying to access the Wizzard and it locks up the system?
Posted: Fri Jul 25, 2025 3:46 pm
by cnckeith
PrestonE wrote: ↑Tue Jul 22, 2025 8:13 pm
report_0008DC111213-1010220080_2025-07-22_19-04-47.zipHello,
We have finally gotten the 3 axis's to sort of work.
X and Y fine, with Z we jumper the Enable X axis to the Z axis and it works.
But, we cannot access the Configuration Wizzard?
When we try we get this screen shot and below is the Report after this happens.
wizzard scrrenshot.png
The machine is not doing anything else in the background.
How can we fix this?
Best Regards,
Preston
this message is letting you know that you have CNC12 in a RUN MODE, so it is running a G code job.
the Wizard can not work with CNC12 while CNC12 is running the machine/g code job.
exit MDI or exit/cancel the G code job being run so the Wizard can interact with CNC12.