Centroid Community CNC Support Forum

Would it be possible to add a check box to the community Fusion post processor that adds spindle speed variation and feedrate variation? Thanks!
Mike

Where is this community Fusion PP???

Yes I could do this, but....
No I will not do this

Simply because as a value in the PP it would be on for the whole time for all tools.

The better way to do is with Pass through manual NC
Then save as a template in your cloud and you could drag and drop it where you want
Example here only for profile roughing.
You can also make different templates with different parameters for SSV and FRV using G10

Uwe

vw_chuck wrote: ↑Wed Jul 02, 2025 11:06 am Where is this community Fusion PP???

here:

viewtopic.php?t=11259

Uwe

Uwe,
Thank you for that idea. I was editing the files in a text editor.
What does this mean, "You can also make different templates with different parameters for SSV and FRV using G10" ? I thought the parameters were only set in the wizard.
Mike

G10 P1982 R0.1
G10 P1983 R100
M94 /70

Will turn on SSV with +-100rpm / 0.1s

You can write parameters with G10

The wizard is just a tool for user convenient to set up CNC12 / PLC / macros / parameters

Everything the wizard is doing can be done in another way too.

Uwe

Thank you!

I've tried this, but when I post the file, the M codes are not in the file. What do I need to set to have them post to the file?
It says you have to modify the post to allow this function.
https://www.autodesk.com/support/techni ... r-HSM.html
https://www.autodesk.com/support/techni ... rking.html
I tried following their instructions, but the "onManualNC" section of the post was not there. So I didn't know how to proceed.

This function was removed from autodesk

Now back on track again
New V3 PP is here:

viewtopic.php?p=101826#p101826

Uwe

Thank you very much!!!