Hello, we just purchased a new KP-3 for our mill and the setup and operation has gone well. But we notice that occasionally, the sensor will remain triggered after a contact causing errors. Sometimes after a touch and release, the LED will stay illuminated or dim. After a gentle finger tap or two, the light will go out and operation can continue.
Is there an adjustment or calibration for this? And if there is a better place to ask this question, please let me know.
Thank You!
KP-3 adjustment to sensitivity?
Moderator: cnckeith
-
ForumShop
- Posts: 6
- Joined: Sun Mar 16, 2025 7:20 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0827181417
- DC3IOB: Yes
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
KP-3 adjustment to sensitivity?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)