I finally got a chance to try out the smoothing and am very pleased with the result
The top part of this carving was done with smoothing off, the bottom with it on.
Settings:
Smoothing - Contouring Mill
Bit - 3/8"in ball end mill, 15% stepover
Wood - tamarind
Carving with/without smoothing
Moderator: cnckeith
-
Tonty
- Posts: 13
- Joined: Tue Dec 31, 2024 11:23 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Carving with/without smoothing
- Attachments
-
1 user liked this post
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)