Hello all,
I'm using the Wizard on the Input Definition page.
When selecting any Input Type, once a type is selected it is not allowed to be moved to the Input Definition.
I must be doing something wrong, help will be appreciated.
Thanks, Bob
Input Type Selection Problem <Solved>
Moderator: cnckeith
-
BobS
- Posts: 4
- Joined: Mon Jul 06, 2020 10:00 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Input Type Selection Problem <Solved>
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
BobS
- Posts: 4
- Joined: Mon Jul 06, 2020 10:00 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: Input Type Selection Problem
Problem solved! Power cycle the Acorn 
(Note: Liking will "up vote" a post in the search results helping others find good information faster)