workpiece offsets - G55 - G59
Moderator: cnckeith
-
mark-5260
- Posts: 1
- Joined: Mon May 12, 2025 5:36 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
workpiece offsets - G55 - G59
I just migrated from Mach4 to Centroid and I have a question... Is it possible to have multiple workpiece offsets using G55, G56, G57, G58 and G59? How do I access those in the Centroid? How to I store multiple workpiece offsets?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
ShawnM
- Community Expert
- Posts: 2977
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: workpiece offsets - G55 - G59
Yes, this is covered in the operator's manual under the Part Setup section and it covers how to set up the various WCS locations.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)