Hello
Hope this makes sense...
I am installing a camera on top of my cnc to be able to trace the item...with help of Lightburn software (hoping that Centroid might add this in the future).
Now let say I would like to probe at the positions x1 y2, x5 y5, x8 y2 etc...
and probe the z direction only...is this possible?
Tnx!
Can you probe at pre defined positions?
Moderator: cnckeith
-
Rare
- Posts: 25
- Joined: Tue Dec 31, 2024 5:09 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Can you probe at pre defined positions?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3521
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Can you probe at pre defined positions?
Yes with a macro no problem, but you will have to write it.
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)