Can you move the line by line cycling thru the gcode? < single block mode>
Posted: Sat May 10, 2025 11:52 pm
Hello
Is there a way to move the machine line by line of the gcode?
lets say your gcode has 4 lines of movement...is there a way move the machine at line1 then line2 etc?
hopefully with the spindle off.
why ...lets say I drilled a hole and messed up by deleting the zero position. I re-zero
and I want to recheck slowly if the program will cut in the same place...with out needing to run the whole program.
Thank you!
Is there a way to move the machine line by line of the gcode?
lets say your gcode has 4 lines of movement...is there a way move the machine at line1 then line2 etc?
hopefully with the spindle off.
why ...lets say I drilled a hole and messed up by deleting the zero position. I re-zero
and I want to recheck slowly if the program will cut in the same place...with out needing to run the whole program.
Thank you!