I have a issus , the drive /axe move for 2 secondes and stop showing .
I'm in the process of re installing a new acorn card from a swap out card programm.
thanks
9031 drive fault
Moderator: cnckeith
-
usinart
- Posts: 147
- Joined: Fri Dec 25, 2020 2:06 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
9031 drive fault
- Attachments
-
- report_98F07B91EC1E-1115237702_2025-04-03_09-46-33.zip
- (1022.13 KiB) Downloaded 3 times
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
usinart
- Posts: 147
- Joined: Fri Dec 25, 2020 2:06 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: 9031 drive fault
And also when the system is active I can turn my drive motor by hand .
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3445
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: 9031 drive fault
DriveOk input is the cause for 9031, maybe the input need to be inverted, or the driver changed between NO and NC.
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)