Schematic for KP3 and TT4 on Oak/AllIn1DC?

[tblough]

Is there a schematic for a KP-3 probe and TT-4 toolsetter on Oak/AllIn1DC?

[centroid467]

I took a look in our schematic database and did not find any on hand.

Are you planning to have the TT-4 always connected?

[tblough]

On my older machines with DP4 and TT1 I've shared the probe tripped signal with a simple splitter cable with two AMP bulkhead connectors. I leave the TT1 connected since it doesn't have a connected signal. Obviously I can't share the tripped signal with the TT4 but I'd like to be able to leave that always connected as well on the newer machines.

[cncsnw]

Assuming that both your KP3 and your TT4 have the "flipper" circuit in the plug -- so their trip signals behave as normally-open -- then I don't see why you cannot wire them in parallel to the PROBE header, as before.

Did you encounter a problem doing that? What were the symptoms?

[tblough]

Marc, the LED did not light on the TT4, and when attempting to set a tool height, I received a message along the lines of the tool touch off wasn't configured. Sorry, I've slept since then and don't remember the exact message and I won't be back to the machine until Monday.

[tblough]

The flipper circuit is what got me. I ran the detect and trip signals to my piggybacked connector like I did for my DP4 and TT1. I conveniently ignored the fact that the newer KP3 and TT4 use active cables for the trip inversion and therefore need +V (pin 2) connected as well. Working now.

[cnckeith]

i asked Chuck to make public the KP-3 to Oak and Allin1DC schematics (overlooked) and will post here when they are live.

[Centroid_Tech2]

KP-3 to ALLIN1DC - https://www.centroidcnc.com/centroid_di ... term=15294

KP-3 to OAK - https://www.centroidcnc.com/centroid_di ... term=15295