Centroid Community CNC Support Forum

I am getting the following error when running a marking operation.
The program is just a simple marking cycle:

O01001
G90
G53
G20
M65

(Mark Holes)
N55 G0 X0.525 Y0.5231
M64

A new report is attached.

This is a known issue with V5.22, and has been corrected in V5.24.

It only required a macro update, so attached is the V5.24 macro. Can replace the file in C:\cncm\system and should correct the issue for V5.22 as well.

Thanks Chris. I decided to go ahead and upgrade to v5.24. I haven't been able to test it out yet due to the weather.