Hi All,
Probably the first post from an active war zone. However, life goes on. Can anyone explain why when I call up the I/O interface (Alt i) on this machine, the descriptions that show up near the bottom of the screen, do not correspond to those called out in PLC (.SRC) file? Is there any way to fix this?
M15, #4587
Moderator: cnckeith
-
cncjeff1
- Posts: 78
- Joined: Mon Apr 27, 2020 2:09 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
M15, #4587
- Attachments
-
- report.zip
- (70.68 KiB) Downloaded 8 times
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
tblough
- Community Expert
- Posts: 3524
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: M15, #4587
Chances are the PLC file has not been compiled.
viewtopic.php?f=61&t=1455&p=8871&hilit=Compile#p8871
viewtopic.php?f=61&t=1455&p=8871&hilit=Compile#p8871
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)