Centroid Community CNC Support Forum

Hello everyone first post here.

I have a older TT-1 toolsetter that came with my machine when I bought it the previous owner never used it I’d like to use it but the plunger seems to be seized up I was wondering if there was any
One that could point me to a disassembly manual or give me some instructions. I have found the current manual however my toolsetter doesn’t have screws on the top that hold it together from as far as I can tell any help is appreciated thanks!

Early models were glued together, and are not designed to be disassembled.

Try some penetrating oil and/or WD40 to free up the plunger.

That makes sense thank you very much!!