How to see graphics
Moderator: cnckeith
-
Tlempicke
- Posts: 175
- Joined: Wed Jul 04, 2018 1:32 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
How to see graphics
In past iterations of the CNC 12 software there was a button at the bottom of the screen where I could switch between the graphic screen or the digital screen while the CNC was cutting. Can I still do this? How?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Sword
- Posts: 832
- Joined: Fri Nov 30, 2018 1:04 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Thorp WI
Re: How to see graphics
If you mean "Run Time Graphics", it's now "Run Job Options". F4 and F10 to toggle on/off, and then the G-code/Graph button is there when a file is running.
Scott
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Tlempicke
- Posts: 175
- Joined: Wed Jul 04, 2018 1:32 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: How to see graphics
Thank you
(Note: Liking will "up vote" a post in the search results helping others find good information faster)