Re: New Build - CNC Plasma Table
Posted: Fri Oct 21, 2022 3:29 pm
Have you tried the contouring smoothing profile?
Centroid Community CNC Support Forum
New Build - CNC Plasma Table
Page 7 of 7
Re: New Build - CNC Plasma Table
Posted: Fri Oct 21, 2022 4:00 pm
I’m not aware of that profile
Re: New Build - CNC Plasma Table
Posted: Fri Oct 21, 2022 5:54 pm
Re: New Build - CNC Plasma Table
Posted: Fri Oct 21, 2022 5:55 pm
Re: New Build - CNC Plasma Table
Posted: Mon Nov 07, 2022 12:28 pm
i used smoothing on and off i found good drawings with cleaned up nodes does better then smoothing on in circles
then using heavy node drawing i found smoothing helped a little .
but nothing suits a properly setup rack pinion gear tight motion no slop
then using heavy node drawing i found smoothing helped a little .
but nothing suits a properly setup rack pinion gear tight motion no slop
Re: New Build - CNC Plasma Table
Posted: Mon Nov 07, 2022 6:29 pm
exactly.. smoothing does little for a good g code program (good = not a bunch of short ratty vectors) running on a good designed machine.
Re: New Build - CNC Plasma Table
Posted: Thu Nov 10, 2022 7:41 pm
My Y-axis is tight but I found some shake on the X-axis as the carriage moves along the gantry. Once I get that cleaned up I think it should cut some smooth lines.