https://a.co/d/iA8764V
Cheap CNCPC that meets requirements: Lenovo Think Center M93P and HP G3, Beelink
Moderator: cnckeith
-
Adaptel
- Posts: 8
- Joined: Thu May 08, 2025 9:02 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Cheap CNCPC that meets requirements: Lenovo Think Center M93P and HP G3, Beelink
I found the perfect CNCPC for use with centroid and it was so cheap that I had little faith that it would be up to the task....but it passes all the PC Tuner tests and works flawlessly with my Acorn board with plenty of horsepower to spare. This $159.00 PC has TWO physlical ethernet ports, Intel N150 processor, 12GB RAM, 512GB SSD, WiFi 6, Bluetooth 6.2, is powered by a USB-C port, and comes with a Windows 11 license. Check it out on Amazon.
https://a.co/d/iA8764V
https://a.co/d/iA8764V
2 users liked this post
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)