Centroid Community CNC Support Forum

Posted: **Fri May 06, 2016 6:34 pm**

Now that I have had the Allin1DC repaired I need to somehow tell the software that I have a right to use it.

Attached is a screenshot of how the program starts up.

How do I satisfy the program?

Posted: **Sat May 07, 2016 6:51 pm**

You don't need to do anything.

As the screen says, Permanent Unlock is ON.

Posted: **Sat May 07, 2016 8:14 pm**

Thank you.

Centroid Community CNC Support Forum

Error Retrieving MPU Serial Number

Re: Error Retrieving MPU Serial Number

Re: Error Retrieving MPU Serial Number

Re: Error Retrieving MPU Serial Number