Page 3 of 3
Re: Acorn with CL-HSS57 Steppers, and KBMG212D, C89
Posted: Mon Aug 09, 2021 11:33 pm
by Bill Griggs
martyscncgarage wrote: ↑Mon Aug 09, 2021 6:34 pm
Then you had a closure of that enable circuit. Are you sure you are on NORMALLY OPEN contact on Acorn relay board?
I will double check inside the Wizard that I have the right state chosen for output 4 & 5.
The pictures show how I have the relays wired.
Re: Acorn with CL-HSS57 Steppers, and KBMG212D, C89
Posted: Mon Aug 09, 2021 11:43 pm
by martyscncgarage
Without the enable, that drive should not have turned on.
Re: Acorn with CL-HSS57 Steppers, and KBMG212D, C89
Posted: Sat Aug 28, 2021 8:12 pm
by Bill Griggs
SUCCESS!!!
Third time is the charm. I had two bad KBMG-212D controller bought from ebay. The 3rd was new and works like a charm. This motor is very quite. Now I can move on with the rest of the restoration.
Thank you Marty for being so patient and helping me trouble shoot the problem. It was just bad luck (and a bit of frugality) that kept me from getting a good driver.
Onward!
Re: Acorn with CL-HSS57 Steppers, and KBMG212D, C89
Posted: Sat Aug 28, 2021 11:47 pm
by martyscncgarage
Bill Griggs wrote: ↑Sat Aug 28, 2021 8:12 pm
SUCCESS!!!
Third time is the charm. I had two bad KBMG-212D controller bought from ebay. The 3rd was new and works like a charm. This motor is very quite. Now I can move on with the rest of the restoration.
Thank you Marty for being so patient and helping me trouble shoot the problem. It was just bad luck (and a bit of frugality) that kept me from getting a good driver.
Onward!
Good to hear Bill