Re: burned OUT what about warranty ?
Posted: Mon Sep 28, 2020 3:55 pm
I feel so too ... 200 dollars is fine for me , problem is that I'm in Europe and it will take some time to arrive here and than custom duties ... and rather stuffeng199 wrote: ↑Mon Sep 28, 2020 12:47 pmThe resistor was probably R136 then. 0.1 ohm according to schematic.Martin Zarnay wrote: ↑Mon Sep 28, 2020 12:29 pm I found that this is an R100 resistor, I did resolder that, a fast DIY solution so will see if I fix it. but nothing there must be more damage on board than that
https://files.seeedstudio.com/wiki/Beag ... EEN_V1.pdf
It goes from chassis GND (ESD_RING) to logic GND (DGND). This would be damaged from a logic and chassis GND mismatch just like the ferrite bead on ACORN.
It is not going to be a warranty repair unless someone is feeling overly generous.
