martyscncgarage wrote: ↑Sun Jun 12, 2022 11:35 am
Need pictures and link to your stepper drive manual, and how you have them connected to Acorn.
driver documentation
la documentation du driver
Re: routeur cnc acorn auto construction
Posted: Sun Jun 12, 2022 12:05 pm
by suntravel
Maybe you need to reverse enable....
Uwe
Re: routeur cnc acorn auto construction
Posted: Sun Jun 12, 2022 12:29 pm
by Filardo
suntravel wrote: ↑Sun Jun 12, 2022 12:05 pm
Maybe you need to reverse enable....
Uwe
already done thank you I have the impression that the axis of the motor remains stuck but which requires that it turn and my driver indicates a default which comes and goes
déjà fait merci
Jai impression que l'axe du moteur reste collé mais qui demande qua tourner
et mon driver indique un default qui va et revient
Re: routeur cnc acorn auto construction
Posted: Sun Jun 12, 2022 5:13 pm
by martyscncgarage
Fresh Report please
F7 Utility
F7 Create Report
In Wizard DB25 mapping what is selected? DB25 or terminal?
In Wizard DB25 mapping what is selected? DB25 or terminal?
[/quo
I'm doing this tonight at work around 5:00 p.m.
Je fais ça ce soir au travail vers 17h00
In Wizard DB25 mapping what is selected? DB25 or terminal?
well i think i found it
not seen behind motor plug
The colors are actually in the same place.
Bon je crois que j'ai trouvé
pas vu derrière la fiche du moteur
Effectivement les couleurs sont aux mêmes emplacement
Re: routeur cnc acorn auto construction
Posted: Mon Jun 13, 2022 4:34 pm
by cnckeith
Re: routeur cnc acorn auto construction
Posted: Mon Jun 13, 2022 4:34 pm
by cnckeith
Re: routeur cnc acorn auto construction
Posted: Mon Jun 13, 2022 4:46 pm
by martyscncgarage
Make SURE you are using the Encoder Extension cable as well
You still have NOT posted a Fresh Report from CNC12
F7 Utility, F7 Create Report
Marty
Re: routeur cnc acorn auto construction
Posted: Tue Jun 14, 2022 12:38 am
by Filardo
martyscncgarage wrote: ↑Mon Jun 13, 2022 4:46 pm
Make SURE you are using the Encoder Extension cable as well
Encodeer extension cable.JPG
You still have NOT posted a Fresh Report from CNC12
F7 Utility, F7 Create Report
Marty
[/
sorry for the report i just posted
can you help me to adjust the axes
x and y 10mm pitch with 1/2 ratio larger pulley on ballscrew
live z axis with 5mm step
désolé pour le rapport je vient de poster
pouvez vous Maider a régler les axes
x et y pas de 10 mm avec un rapport de 1/2 plus grande poulie sur la vis a bille
axe z en direct avec un pas de 5 mm