Centroid Community CNC Support Forum • CNC Depot Spindle with Acorn and Hitachi WJ200 - Page 2

Page 2 of 2

Re: CNC Depot Spindle with Acorn and Hitachi WJ200

Posted: Fri Jun 07, 2024 1:29 pm

by cnckeith

here is rev3 of the wj200 setup doc

autotune cnc depot with wj200_rev3.pdf: (110.41 KiB) Downloaded 23 times

Re: CNC Depot Spindle with Acorn and Hitachi WJ200

Posted: Fri Jun 07, 2024 1:31 pm

by cnckeith

double check your analog out / in wiring

Re: CNC Depot Spindle with Acorn and Hitachi WJ200

Posted: Fri Jun 07, 2024 1:33 pm

by cnckeith

15223 was updated on 4-24-24 make sure you are using the latest.