CNC Depot Spindle with Acorn and Hitachi WJ200 - Page 2 - Centroid Community CNC Support Forum

cnckeith: Site Admin; Posts: 8897; Joined: Wed Mar 03, 2010 4:23 pm; Acorn CNC Controller: Yes; Allin1DC CNC Controller: Yes; Oak CNC controller: Yes; CNC Control System Serial Number: none; DC3IOB: Yes; CNC11: Yes; CPU10 or CPU7: Yes; Contact:
Contact cnckeith

Website

Post by cnckeith » Fri Jun 07, 2024 1:29 pm

here is rev3 of the wj200 setup doc

(Note: Liking will "up vote" a post in the search results helping others find good information faster)

cnckeith: Site Admin; Posts: 8897; Joined: Wed Mar 03, 2010 4:23 pm; Acorn CNC Controller: Yes; Allin1DC CNC Controller: Yes; Oak CNC controller: Yes; CNC Control System Serial Number: none; DC3IOB: Yes; CNC11: Yes; CPU10 or CPU7: Yes; Contact:
Contact cnckeith

Website

Post by cnckeith » Fri Jun 07, 2024 1:31 pm

double check your analog out / in wiring

(Note: Liking will "up vote" a post in the search results helping others find good information faster)

cnckeith: Site Admin; Posts: 8897; Joined: Wed Mar 03, 2010 4:23 pm; Acorn CNC Controller: Yes; Allin1DC CNC Controller: Yes; Oak CNC controller: Yes; CNC Control System Serial Number: none; DC3IOB: Yes; CNC11: Yes; CPU10 or CPU7: Yes; Contact:
Contact cnckeith

Website

Post by cnckeith » Fri Jun 07, 2024 1:33 pm

15223 was updated on 4-24-24 make sure you are using the latest.

(Note: Liking will "up vote" a post in the search results helping others find good information faster)