Power Drawbar Getting Stuck
Moderator: cnckeith
-
RJS100
- Posts: 716
- Joined: Tue Oct 20, 2020 8:41 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Arizona
Re: Power Drawbar Getting Stuck
Thanks Tom. I checked that out as well, and even put anti-seize on the key just to rule it out.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
RJS100
- Posts: 716
- Joined: Tue Oct 20, 2020 8:41 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Arizona
Re: Power Drawbar Getting Stuck
SOLVED - Finaly after many attempts... I put a scant amount of anti-seize on and it has not got stuck in months! At the end of the day, what looked like rubbing and a soft spindle was actually had deposits create from too much anti-seize. Works like a charm now!
(Note: Liking will "up vote" a post in the search results helping others find good information faster)