Centroid Community CNC Support Forum

Posted: **Wed Apr 19, 2023 3:34 pm**

Yes I saw the E-stop contactor circuit and it shows the contactor connecting to the relay but the c86 schetmiac also shows the connection to the relay so I was wondering how to integrate that unless relay can have two wires...?

You must have missed the post where I said to keep them separate. There is no logical reason to have a C86 interface board in an estop circuit.

Posted: **Wed Apr 19, 2023 5:13 pm**

As Gary said, keep them separate. Wire the estop per the Centroid diagram.

Posted: **Wed Apr 19, 2023 5:16 pm**

ShawnM wrote: ↑Wed Apr 19, 2023 5:13 pm As Gary said, keep them separate. Wire the estop per the Centroid diagram.

Sorry I missed that, thanks so much for your help.

Centroid Community CNC Support Forum

Wiring together, C86ACCP, with E-stop, and contactor

Re: Wiring together, C86ACCP, with E-stop, and contactor

Re: Wiring together, C86ACCP, with E-stop, and contactor

Re: Wiring together, C86ACCP, with E-stop, and contactor