Centroid Community CNC Support Forum • encoder requirements - Page 2

Page 2 of 2

Re: encoder requirements

Posted: Wed Jun 08, 2022 4:48 pm

by Navanod

Planet Omronicron it is--at least for now. Thanks for answering all my question Uwe it was very helpful:)

Re: encoder requirements

Posted: Thu Jun 09, 2022 3:50 am

by Spartan117

suntravel wrote: ↑Wed Jun 08, 2022 7:39 am I have only a 400ppr Encoder on my mill, but rigid tapping works perfect, I run it on tapping up to 3000 rpm.

No need for a very high resolution encoder for tapping.

Good to know... My Emco is equipped with an 360ppr-Encoder, so i will give that one a try first.
Emco did rigid tapping with it, too, afaik