
Password requirements
Moderator: cnckeith
-
- Community Expert
- Posts: 3023
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Password requirements
We’re talking about a macro, yes? Not the nuclear launch codes. 

(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 416
- Joined: Tue Dec 11, 2018 4:03 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA80C8B8-0905181172
E415F6F70BC3-0318203049
98F07B91FC6B-0123236802 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: UK East Coast
Re: Password requirements
Sounds like the OP needs to review his security - Workshop CCTV, sensors, alarm, strong admin password, disconnected LAN etc. If he is that concerned perhaps surround the whole workshop with a full faraday cage 

Hope this helps
Nigel
"You can lead a horse to water but you cannot force it to drink"
Nigel
"You can lead a horse to water but you cannot force it to drink"
(Note: Liking will "up vote" a post in the search results helping others find good information faster)