Re: M400 control freezing up when jogging
Posted: Thu Jun 11, 2020 1:08 pm
Here is a picture of the cabinet.
I think you should probably go back to MSI. If they purchased the Estuns from Centroid, they could get support from Centroid in tuning.jake2465 wrote: ↑Thu Jun 11, 2020 1:03 pm Jefco MSI from West Alexandria Ohio did the installation for me. When the install was being performed, I was informed that they were much more used to installing Yaskawa servos with their retrofits and the only Estun servo drive installs they performed before my retrofit was with Acorn boards. In other words, they had not had to tune a Estun system with PID before because they had only done step and direction with them in the past. I was their first customer with that setup according to them.
The cabinet looks quite nice and professional. Cables and wires have been routed in conduit wherever possible.
It sounds like you paid them for a service. They should see it through...