Works as advertised! Proofed it out. Set the Z Ref tool in and get your number off the 123 block then put the new tool in and do the same routine. All the offsets are where they should be.
Take away: DONT RUSH THE SETUP! Proof the tool to back up its in the right place.
Thanks again everyone!
Setting ref tool heights
Moderator: cnckeith
-
Beechdrvr
- Posts: 25
- Joined: Sun Sep 30, 2018 10:05 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Connecticut
Re: Setting ref tool heights
(Note: Liking will "up vote" a post in the search results helping others find good information faster)