Need to make a dummy code

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
cnckeith
Site Admin
Posts: 8898
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:
Contact cnckeith

Re: Need to make a dummy code

Post by cnckeith »

Arrow wrote: ↑Thu Feb 21, 2019 4:36 pm Not sure if this is what you're talkin about or not. Or if the acorn software works the way the regular centroid software does. But from the control parameters page if you put jog panel required to yes it will make you hit cycle start twice before the job runs. First Press brings the job up, 2nd press start the job
yes,thanks.. i even made a video on how to do it.. viewtopic.php?f=61&t=1452&p=8859&hilit= ... tart#p8859
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html

Top
Post Reply

Return to “Centroid Acorn CNC Controller”