Doc's Patented Stupid Questions Thread!
Moderator: cnckeith
-
tblough
- Community Expert
- Posts: 3529
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Doc's Patented Stupid Questions Thread!
Johnnytoro - check your tool table and make sure the tool number you are using has a diameter listed in the table. The graphing function uses the tool diameters from the table to show the tool - no diameter - to trail.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Johnnytoro
- Posts: 5
- Joined: Sun Sep 09, 2018 12:27 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: B0D5CC39B9E5-0530180940
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: Doc's Patented Stupid Questions Thread!
Thanks..that did it! I ran a sim with
a .250 upcut and it plotted....60°vbit didn't
a .250 upcut and it plotted....60°vbit didn't
(Note: Liking will "up vote" a post in the search results helping others find good information faster)