Page 2 of 2

Re: E-Stop input has stopped working on DYNA 2400 Acorn Refit

Posted: Fri Nov 09, 2018 5:17 pm
by martyscncgarage
I guess you will have to swap the board and check it out...

Re: E-Stop input has stopped working on DYNA 2400 Acorn Refit

Posted: Mon Nov 19, 2018 3:25 pm
by Grifftek
I swapped the board from my G540 system and the e-stop input works on the second board just like it did when it was first wired up to the now faulty board.
I can either use this board on a machine that doesn't need the db25, rewire the e-stop to the green connectors and leave that input faulty, or replace the chip! my anal retentiveness will not be happy knowing there is a bad input.....but I guess I could get used to it! Strange disease!

Bill

Re: E-Stop input has stopped working on DYNA 2400 Acorn Refit

Posted: Mon Nov 19, 2018 3:39 pm
by martyscncgarage
Grifftek wrote: Mon Nov 19, 2018 3:25 pm I swapped the board from my G540 system and the e-stop input works on the second board just like it did when it was first wired up to the now faulty board.
I can either use this board on a machine that doesn't need the db25, rewire the e-stop to the green connectors and leave that input faulty, or replace the chip! my anal retentiveness will not be happy knowing there is a bad input.....but I guess I could get used to it! Strange disease!

Bill
You could always ask for an RMA.