Page 2 of 2
Re: reversed direction
Posted: Mon Oct 29, 2018 10:14 am
by phill05
cnckeith wrote: ↑Mon Oct 29, 2018 9:07 am
please post a copy of the test program
would not load Ptest -tap file so I'll try to paste here.
Re: reversed direction
Posted: Mon Oct 29, 2018 10:59 am
by cnckeith
please rename the file. .cnc and post.
Re: reversed direction
Posted: Mon Oct 29, 2018 11:46 am
by phill05
cnckeith wrote: ↑Mon Oct 29, 2018 10:59 am
please rename the file. .cnc and post.
Re: reversed direction
Posted: Mon Oct 29, 2018 12:24 pm
by martyscncgarage
If it were me, I would make my X axis spindle left/right and my moving table, Y axis front/back.
Seems more logical to me.....
Re: reversed direction
Posted: Mon Oct 29, 2018 12:34 pm
by cnckeith
ok.. if the Ptest program flips on the table compared to the CNC12 graphics of the g code on the screen... then its the motor wiring that is backwards.
i've set up a bunch of moving table machines over the years.. i always make the table the Y axis. see pdf attached.