Centroid Community CNC Support Forum

Sure, change the rules.

yesterday I tried my hand at boring with Intercon and I must say it works great!!
A couple general questions
- I exported the intercon file but I don’t have a viewer I guess I need to save it as an NC file. I tried to save it in the offline version but didn’t see a way to save it as something I could open

Posting in the offline version seems to have issues… maybe down rev 5.08…? Is there a newer version???
I’m getting a message that spindle direction is set to off in block n0002.
EDIT I got the cnc file off the lathe computer
EDIT 2 putting the tool table from the lathe computer in fixed the problem

Current offline Version is 5.3
The tool lib must be setup ok to work with Intercon.

You can use the graph in Intercon to view the toolpath

Uwe

I am not sure of the correct method, but I create a report out of my machine that is all set up and restore that report into Intercom to get the tool libraries and everything the same as the machine. Gary