Re: AcornSix Lathe - C-Axis Configuration
Posted: Thu Apr 24, 2025 11:38 am
hi Uwe,
understand, so i have a 2000 Line Encoder on the spindle, more is not supported because of high rev ?
a 9000 line encoder would be an issue for closed loop C-Axis because much slower. understand.
but why is it not possible to use the 2000 Line Encoder for the C-Axis ? of course, less resolution, but maybe enough ? i have to check, if i can fit a second encoder to my spindle.
understand, so i have a 2000 Line Encoder on the spindle, more is not supported because of high rev ?
a 9000 line encoder would be an issue for closed loop C-Axis because much slower. understand.
but why is it not possible to use the 2000 Line Encoder for the C-Axis ? of course, less resolution, but maybe enough ? i have to check, if i can fit a second encoder to my spindle.