Page 2 of 2
Re: calibration not going well
Posted: Fri Apr 25, 2025 7:47 am
by Terry1956
this is the new report off the C12 program.
Re: calibration not going well
Posted: Fri Apr 25, 2025 7:53 am
by Chaz
Hi, thanks, will take a look. Did you get my number? Ive also just spotted your 'wanted' thread on the Denford forums. Ive got an Orac, running Centroid .... if you are interested.
Re: calibration not going well
Posted: Fri Apr 25, 2025 7:57 am
by Chaz
According to the report, your mm/rev is still 5.08. Have you edited this via the Wizard and saved it or alternately via the setup menu and saved it?
Axis Label Motor Encoder Lash Comp. Limit Home Dir Screw
mm/rev counts/rev. (mm) - + - + Rev Comp
1 X 5.0800000000000001 4000 0.0000 0 0 0 0 N N
2 Y 24.9427999999999841 4000 0.0000 0 0 0 0 Y N
3 Z 5.0800000000000001 4000 0.0000 0 0 0 0 N N
4 N 4.0000000000000000 4000 0.0000 0 0 0 0 N N